After uploading the correct firmware, disconnect your device from your computer and power it via LiPoly or AAA battery pack.

Pairing device to PyLeap

Once powered, press the small Reset button in the center of the board (Circuit Playground Bluefruit) or on the top right of the board (CLUE). When the blue light flashes, press the Reset button again.

When done correctly, the LEDs flash yellow, followed by solid blue. Once this occurs, the board will continuously be in discovery mode.

Scan & Connect

When your Adafruit device is in discovery mode, hold it very close to your iPhone or iPad to pair. 

Below the spinning Blinka, you'll notice a status indicator that will let you know your current pairing status.

Once you've found your device and received the Bluetooth Pairing Request message, press Pair to pair your board to your iPhone or iPad.

If your Circuit Playground Bluefruit doesn't appear:

1. Verify that the green On light is lit.
2. Make sure your Adafruit device is running the correct firmware. See the CircuitPython page in this guide.
3. Try resetting the Adafruit device by pressing the small Reset button near the center of the board.