Let's load a game! For example, here's a link to Run, Blinka, Run! To open the game in the MakeCode Arcade editor, first, click the share link below. This will allow you to play the game in the browser right away.
Then, click on the Show Code button in the upper left corner. The shows the code for the game, and by clicking the Edit button in the upper right corner, it'll open into the editor where you can upload it to your PyGamer/PyBadge.
Once you have a game working on the MakeCode Arcade web editor, it's time to download it and flash it onto your board.
Board Definition
In order to load a game made in MakeCode Arcade onto the PyBadge, first choose the proper board definition inside of MakeCode. Click the ellipsis (...) next to DOWNLOAD and then the Choose Hardware item.
This will cause the game .uf2 file for your particular board to be saved to your hard drive. You only need to do this the first time you use a new board. Thereafter you can simply click the Download button on the MakeCode Arcade editor page.
Bootloader Mode
Now, we'll put the board into bootloader mode so we can drag on the saved .uf2 file. On the back side of the board you'll see a reset button at the top. Make sure the board is plugged into your computer via USB with a USB micro B to A data cable. Also, be sure the board is turned on.
Then, press the reset button. This will initiate bootloader mode.
When the board is in bootloader mode you'll see a screen similar to this one show up.
Drag and Drop
Now that the board is in bootloader mode, you should see a BADGEBOOT drive show up on your computer as a USB flash drive. Simply drag the arcade game .uf2 file onto the drive.
Play!
That's all there is to it! Once the file is copied over the board will restart and launch the game!
Keep an eye on Adafruit.com for additional game related content.
Page last edited March 08, 2024
Text editor powered by tinymce.
