Connect Battery

Plug in the JST cable from the battery to the JST port on the PyBadge.

Connect Reset Button

Plug in the jumper cables from the button to the headers on the pybadge. Connect one wire to a GND pin and the other to RESET.

Connect Switch

Plug in the cables from the switch to the headers on the PyBadge. Connect one wire to a GND pin and the other to the EN pin.

This guide was first published on Apr 24, 2020. It was last updated on Apr 28, 2020.

This page (PyBadge Connections) was last updated on Apr 21, 2020.

Text editor powered by tinymce.