Hardware

Use the following hardware to mount the breakout board.

  • 4x 10mm f/f M2.5 standoff
  • 8x M2.5 8mm screws

Install PCB

Secure the four standoffs to the mounting holes on the breakout PCB. Place the standoffs over the four mounting holes on the 3D printed mount. Use 4x M2.5 x 8mm long screws to secure the board to the mount.

Secured PCB

Reference the photo for the correct orientation. The PCB should be facing away from the standoffs.

Connect STEMMA cable

Plug in the STEMMA cable into the input side of the breakout board.

Install PyBadge

Place the PyBadge PCB onto the mount. Fit the posts on the standoffs into the mounting holes.

Connect PyBadge

Reference the photo for the correct orientation. Plug in the STEMMA cable from the IR thermal camera breakout to the STEMMA port on the PyBadge.

This guide was first published on Apr 24, 2020. It was last updated on Apr 24, 2020.

This page (Install MLX90640) was last updated on Apr 21, 2020.

Text editor powered by tinymce.