Installing CoverThe cover is secured to the mount using hardware screws. |
|
Install CoverPlace the cover on top of the PyBadge and carefully press the buttons through the cover. |
|
Install SwitchThe slide switch is press fitted into a built-in holder on the cover. Insert the switch at an angle and firmly press the body of the switch into the holder on the cover. |
|
Install ButtonThe button is press fitted into a built-in holder on the cover. Insert the button at an angle and firmly press the body of the button into the holder on the cover. |
|
Cover ScrewsUse the following hardware screws to secure the cover to the mount.
|
|
Secured CoverInsert the M2.5 screws through the cover and mount. Install and fasten the nuts tightly. |
Install Cover
This guide was first published on Apr 24, 2020. It was last updated on Apr 24, 2020.
This page (Install Cover) was last updated on Aug 09, 2020.