Wiring Toggle Switch

The slide switch will be wired to the male and female 2-pin JST cables. Using wire cutters, trim the wires short so they're the following length.

  • 80mm (3.15inch)

Wired Toggle Switch

The voltage (red) wires are connected to the middle pin and either left or right pin on the switch. The ground (black) wires are connected to each other. Use piece of heat shrink tubing to insulate the exposed connection.

This guide was first published on Oct 28, 2019. It was last updated on May 24, 2024.

This page (Toggle Switch) was last updated on Mar 08, 2024.

Text editor powered by tinymce.