Install Knuckle to Clamp

Fit the knuckle mount onto the clamp. The grove slides on to the nub. These two pieces fit together so they are kept aligned. 

Insert Hex Nut

Place an M3 hex nut onto the knuckle mount. Press the hex nut into the polygon shaped recess. 

Secure Knuckle to Clamp

Insert and fasten an M3 x 8mm long machine screw through the hole. This secures the knuckle mount to the clamp.

Secured Knuckle

The knuckle mount should be securely mounted to the clamp.

Install D-Ring

Insert and fasten the 1/4"-20 tripod D-ring screw into the plate.

Install Rubber Washer (optional)

A rubber washer is used for getting a better grip to the display. This was printed in Ninjaflex TPU filament.

Insert Cap Nut

Fit an M5 hex nut onto the recess on the side of the knuckle mount.

Install M5 Screw

Place the tripod plate onto the knuckle mount. Insert the M5 x 20mm long screw through the hole of both pieces. Fasten the M5 screw into the hex nut.

Installed Knuckle

Use the M5 screw to tighten or loosen the tripod plate and knuckle mount.

Install Clamp to Gamepad

Open the clamp slightly and fit it over the PS4 gamepad.

Insert M3 Screw

Pinch the tabs on the end of the clamp together. Insert an M3 x 8mm long machine screw through the holes on both tabs.

Secured Clamp

Use an M3 hex nut to secure the tabs on the clamp.

Lock Nut (Optional)

A hex nut with a nylon insert will prevent the hex nut from becoming loose.

Menu Button

A hole in the clamp allows the menu button to be accessible.

Install Display

Get the HDMI display onto the clamp mount and fasten the tripod screw.

Adjust Display

Keep the display aligned in the desired position while tightening the tripod screw.

Adjust Viewing Angle

Use the M5 screw and hex nut to tighten or loosen the hinge.

Final Build

And now you're ready to game on!

This guide was first published on May 05, 2020. It was last updated on May 05, 2020.
This page (Assembly) was last updated on May 05, 2020.