3D Printed Parts

The parts are designed to 3D print without any support material. Use PLA filament. The STL files are oriented to print "as-is".

• ps4-clamp.stl
• ps4-knuckle.stl
• ps4-adapter.stl
• ps4-plate.stl
• ps4-washer.stl

Slicing Parts

No supports are required. Slice with settings for PLA material. 

The parts were sliced using CURA using the slice settings below.

• PLA filament 220c extruder
• 0.2 layer height
• 10% gyroid infill
• 60mm/s print speed
• 60c heated bed

CAD Assembly

The knuckle adapter attaches to the clamp using an M3 screw and cap nut. The tripod plate is mounted to the knuckle adapter using an M5 screw and cap nut. The clamp is secured to the gamepad using an M3 screw and locknut.

Glue Knuckle Mount

The knuckle and adapter parts are glued together. Apply a few drops of super glue to the flat surface of the knuckle. Align the adapter with the knuckle and press them together. Allow glue to cure before assembling.

Glued Knuckle

The knuckle and adapter were separated to avoid using support material.