Prep Wires

Lay Kippah and Powerboost 1000c on the enclosure to get an idea of wire length. A bit of extra slack is OK, you can shorten it later. 26AWG silicone-coated stranded wire is recommend for power.

Tin Kippah and Wires

Strip and tin the two wires then, apply solder to the 5V and GND pins on the Kippah. 

Connect wires to Kippah

Appy heat to the solder joints on Kippah and place the tip of the wires to the 5V and GND pads.

Wired Kippah

This stylin' Kippah is ready for sum Raspberré Pi!

This guide was first published on Jun 15, 2015. It was last updated on Jun 15, 2015.

This page (Kippah) was last updated on Jun 12, 2015.

Text editor powered by tinymce.