Slicer Settings
You can use the settings below as a reference. The parts are oriented in the center of the bed and ready to print "as is". They do not require any support material.
|
ChargeCase.stl ChargeFrame.stl ChargeFace.stl ChargeCover.stl |
230c 2 shells 3 top/bottom shells 50mms print speed 10% infill |
about an hour and a half to print all four parts. |
Modify Design
The parts were modeled in Autodesk 123D Design and available to modify. The file includes the original solids and sketches.
Page last edited May 11, 2015
Text editor powered by tinymce.
