Place Servo

Align the servo tabs between the walls on the printed holder. Pass the servo wires to the opposite side of the holder.

Servo Horn

Attach the included single arm horn with the included smaller screw.

Servo Screws

Secure the servo with the two longer screws included in the servo kit. Fasten screws to each tab.

Servo Flag

Align the printed flag to the servo horn. Press-fit the flag channel to servo arm.

Use the smallest horn screw to fasten the flag to the servo.

Mount Servo Holder

Align the assembled servo holder to the left side (opposite of the side buttons) of the MagTag case.

Plug JST connection

Guide the servo wires around the magnetic feet to keep the cable tidy.

The servo JST plug into the D10 port (closest port to the side buttons)

Mount to case

Magnetic feet can mount to a ferrous surface or on a desk with the built-in stand!

A magnetic Pin Back can adhere to non ferrous surfaces to help the case attach to something like an aluminum pool gate!