Mount Display

Save Subscribe

Install display buttons

Now is a good time to insert that strip of buttons printed in Ninjaflex. The buttons should fit into the cuts on the enclosure.

Install PiTFT

Fit the PiTFT into the enclosure and line up the buttons and mounting holes. Grab four #4-40 3/8 flat phillips machine screws.

Mount PiTFT

Hold the PiTFT in place while you insert and secure four machine screws into the PCB. These should fasten all the way through the PCB and the standoffs.

 Pi Cable Perma-Proto 

This guide was first published on May 14, 2015. It was last updated on May 14, 2015.

This page (Mount Display) was last updated on Apr 27, 2015.

Text editor powered by tinymce.