Mount the fan

Plug the fan cable into the port by the headers on the Pi. Align the sticky thermal pads to the chips on the Pi.

Gently apply pressure to the spring screws to the inner screw (the two holes without the yellow outlines) mounts on the Pi.

Camera ribbon cable

Insert the included 150mm camera cable into the CAM/DISP 0 port as follows:

Gently pull the two connector latches on each side of the camera ribbon connector.

The cable should  face toward the USB A ports. Press fit the ribbon cable into the camera port. 

Push each side of the latch connector one at a time to firmly attach the ribbon cable.

Mount Pi

Align the USB A ports to the cutout on the bottom printed case.

Fasten it using three M2.5x6mm screws.

Leave the standoff next to the USB C port without a screw to accommodate the display standoff.

Display standoff

Use one of the HyperPixel standoffs (included) to help level the display when attached to the Pi.

Attach the standoff next to the longer ribbon cable port.

Make sure the camera ribbon cable is laying towards the USB A ports.

Add the included header extender to the display and mount to the headers on the Pi.

Peel the protective film

Remove the protective film off the display before attaching the front case.

Slide the front case rails under the display with the USB port cutout first.

Press fit the rails one side at a time to snap fit together.

Assemble stem 

Align the stem to the sleeve and fasten the tabs on the sides with two M2.5x6mm screws.

The front screw holes use two M2.5x5mm screws, fasten from underneath the sleeve.

Stem ribbon cable

Align the sleeve to the screen cutout.

Insert the ribbon cable into the stem cavity.

Place bottom mouth 

Align the ribbon cutout to the bottom mouth part and place over the screw mounts on the end of the stem.

Pass the ribbon cable through the cutout.

Fasten the mouth to the stem. The two screws on the outer side are M2.5x6mm long. The two center screws are M2.5x5mm long.

Attach the camera module

Gently pull the two connector latches on each side of the camera module.

Press fit the ribbon cable into the camera port. 

Push each latch connector one at a time to firmly attach the ribbon cable.

Angle the camera module to press fit into the bottom nubs.

Fasten with two M2x6mm screws to the top standoffs.

Attach the top mouth

Place the top mouth part over the screw holes and fasten with three to six M2.5x6mm screws.

To secure the sleeve to the case, use two M2.5x6mm screw on the sides.

Attach the leaf 

The leaf press fits by gently bending one side of the cutout and place over the stem.

Tripod attachment

The tripod sleeve press fits to the bottom of the case and can be fasten with two M2.5x6mm screws.

A 3/8" to 1/4" adapter screw threads into the screw hole.