Designed to Print

This project is just two pieces! They are optimized to print on any FDM 3d printer with a minim build area of 150mm x 150mm x 100mm. Perfect for printing your Printrbot, TAZ4, RepRap or makerbot. Check out info below for recommended slicer settings.

piboy-top.stl
piboy-bottom.stl
PLA @230
2 shells
10% Infil
0.2 layer height
90/120 speeds
No Raft 
No Support

Snap Fit

The two pieces snap together and are secured with philips screws. The Raspberry Pi, PowerBoost 500 and Micro Lipo charger are mounted to the piboy-bottom.stl part with #6-32 x 1/2' phillips screws.

Favorite Color

The tolerances are optimized for PLA filament but may work with ABS and other material types. Since the enclosure is only two pieces, it's easy to swap out cases for different colors!

No Support

This design is optimized to print with no support material.

This guide was first published on Jul 02, 2014. It was last updated on Jul 02, 2014.

This page (3D Printing) was last updated on Jun 25, 2014.

Text editor powered by tinymce.