Camera Cable

Start by installing the camera’s ribbon cable through the slit in the front cover. Use M2x5mm screws to mount the standoffs. 

Short standoffs secure the camera to the front while the Pi is secured to the back with M2.5x5mm machine screws.

Mount Pi

Align the USB ports to to edge of the printed part. Gently bend the camera cable around the Pi to connect.

Attach Display

Use the included GPIO riser to fit the display over the Pi.

Attach Screen cover

Place screen cover at an angle, over the display and ribbon cable.

Align snap fits 

Gently bend the two parts over the snap fits to attach the case.

Tripod attachment

Use M3x10mm screws to attach the tripod mount.

Fit a 3/8" to 1/4" Adapter Screw to mount a tripod.  

Camera cover

Align the cut out on the camera cover part over the ribbon cable. 

Press fit the three tabs into the slots on the case to attach.

Pan tilt swivel 

This tilt ball head makes a nice addition and allows you to position the camera in all sorts of different angles.