Parts List (Pre 2017)

If you have an older version of the kit (purchased before 2017) these are the contents:

The (pre-2017) Internet of Things Printer Project Pack for Raspberry Pi includes the following items:

Not included with the kit, the following tools and items are also needed:

  • 4GB or larger SD card (or microSD card with full-size adapter)
  • SD (or microSD) card reader
  • USB keyboard (and mouse, if installing from NOOBS GUI), maybe a hub as well
  • Monitor (HDMI or composite) and cable
  • USB cable: A to micro B
  • Small screwdriver
  • Soldering iron and solder
  • Wire cutter and stripper
  • A wireless (WiFi) internet access point
  • Desktop or laptop computer with USB, internet connection and at least one gigabyte of free disk space for downloading and uncompressing software
  • Optional: sticky tape, heat-shrink tubing

The SD card will remain installed in the device; the remaining parts from this list are needed only during setup.

This guide was first published on Apr 12, 2013. It was last updated on Oct 15, 2018. This page (Parts List (Pre 2017)) was last updated on Apr 22, 2017.