Wiring NeoPixel

Use the jumper cable to create a 3-wire cable for connecting the NeoPixel to the CRICKIT board.

Cut the socket ends off and solder the wires to the DIN, 5V and GND pads on the NeoPixel.

Motor Extension Cable

The motor ships with prewired with a short cable and needs to be extended to reach the CRICKIT board.

Use the jumper cable to create a 2-wire extension cable for the motor.

Wiring Photo Interrupter

Use the jumper cable to create a 4-wire cable to connect the photo interrupter to the CRICKIT board.

Cut the socket ends of the wires and solder the wires to the L, VCC, GND and OUT pins on the photo interrupter.

This guide was first published on Feb 14, 2022. It was last updated on 2022-02-14 22:34:34 -0500.

This page (Wiring) was last updated on Feb 14, 2022.

Text editor powered by tinymce.