For this project you will need:

30 FLORA NeoPixel RGB LEDs
FLORA main board
3-ply conductive thread
3 x AAA battery holder with JST connector
1 pair suspenders
sewing needle
sewing machine and thread to match suspenders
sharp scissors
measuring tape or ruler
tailor's chalk

Conductive thread will carry signal and current from the main board to the pixels.

You'll use a needle and to stitch up the circuit.

Clear nail polish or fray check to seal knots

A sewing machine helps make this project fun and easy.

Sharp scissors are a must!

You will need a good quality basic multimeter that can measure voltage and continuity.

Click here to buy a basic multimeter.

Click here to buy a top of the line multimeter.

Click here to buy a pocket multimeter.

Don't forget to learn how to use your multimeter too!

To mark out your circuit use a water-soluble embroidery marker or tailor's chalk.

This guide was first published on Jun 05, 2013. It was last updated on Jun 05, 2013.

This page (Tools & Supplies) was last updated on Jun 04, 2013.

Text editor powered by tinymce.

Search