Cable for IR Receiver

Use a 3-wire ribbon cable to connect the IR receiver to the Perma Proto.

Measure and cut the ribbon cable so it's about 3in (76mm) in length.

Solder Cable to IR Receiver

Trim the leads short before soldering the wires. 

Solder the three wires from the cable to the three pins on the IR Receiver.

Wired IR Receiver

Double check the three wires have been properly soldered to the pins on the IR Receiver.

This guide was first published on Jul 13, 2022. It was last updated on 2022-07-13 08:12:45 -0400.

This page (Wiring IR Receiver) was last updated on Aug 23, 2022.

Text editor powered by tinymce.