This fully-assembled pan-tilt kit is the perfect way to give your project full range motion with two micro servos. The pan-tilt can rotate roughly 180° from side-to-side and...
Out of Stock
You have some frickin' sharks at your lair, and you're thinking "it would be really great if I could attach some lasers to them" and then you see these little laser...
$18.95
In Stock
What's Feather-shaped and has an ESP32-S2 WiFi module? What has a STEMMA QT connector for I2C devices? What has your favorite Espressif WiFi microcontroller and lots of Flash and...
guides with product
Out of Stock
A Feather board without ambition is a Feather board without FeatherWings! This is the 8-Channel PWM or Servo FeatherWing, you can add 8 x 12-bit PWM outputs to...
guides with product
Out of Stock
This is the FeatherWing Doubler - a prototyping add-on and more for all Feather boards. This is similar to our
guides with product
Out of Stock
This is a generic Wii Nunchuck controller, we haven't tried it with a Wii but it does work great with the Video Game shield, and all the microcontroller code we tried. May come in...
$12.50
In Stock
Dig out that old Wii controller and use it as a sleek controller for your next robot if you like. The Adafruit Adafruit Wii Nunchuck Breakout Adapter fits snugly into the Wii connector...
$2.95
In Stock
Stretch out your servo connections with this flexible servo extension cord. It has a 3 pin shrouded "male" connection to plug your servo into and then, 30cm later, a 3 pin...
$1.95
In Stock
This 4-wire cable is a little over 100mm / 4" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH these are 1mm pitch instead of...
Out of Stock
Totaling 380 pieces, this M2.5 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel your maker...
guides with product
Out of Stock
This is an FCC/CE certified and UL listed power supply. Need a lot of 5V power? This switching supply gives a clean regulated 5V output at up to 2000mA. 110 or 240 input, so it works...
$7.95
In Stock
If you need to connect a DC power wall wart to a board that doesn't have a DC jack - this adapter will come in very handy! There is a 2.1mm DC jack on one end, and a screw terminal...
$2.00
In Stock
Handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires are 3" (75mm) long and come in a 'strip' of 20 (2 pieces of each...
$1.95
In Stock
As technology changes and adapts, so does Adafruit, and speaking of adapting, this adapter has a 2.1mm barrel jack socket and a USB C...
$5.50
In Stock
Double up your power adapters with this wonderfully simple 2-way power jack splitter. All you have to do is connect a standard 5.5mm/2.1mm sized plug into one end, and behold, two...
$2.95
In Stock