Measure wires

Use silicone wire to solder to the ends of the nOOds. Denote the positive and negative connections with markings or with red (+) and black (-) wires.

Use heat shrink tubing to protect the soldered ends. Slip a piece on before soldering and then slip it over the joint and heat to seal.

Use a flat head screwdriver on the terminal blocks to attach the wires into the + and - CC out connectors. 

Measure and cut a JST socket wire for power and connect to the 3-5 Vin terminal  blocks. 

Assemble case

Note the + and - labels on the case to correctly align the terminal blocks on the board to place inside the case.

Align the lid part to the mini DIP switches. Place one side of the lid over the snap fit part and then use force to snap fit the other side into place.

Use M2.5x5mm screws on the two tabs to mount the case.

Attach nOOds

The LED nOOds press fit into the channels on the sign part. Align the strip and gently press fit at the same angle so the filament strip does not twist along the channel. 

Connect power and adjust the current to achieve to the desired brightness.