Wiring for this project is very simple. First, remove the green terminal block from the Power Relay. 

Then, connect the JST PH wire to the top-most JST PH port on the FunHouse.

After that, plug the white wire into the left terminal and the black wire into the right terminal.

Next, screw them down and put the terminal block back in the Power Relay. Make sure that the terminal block is fully inserted and you can't see the screws.

Finally, plug your FunHouse into the wall or into the outlet of the power switch that is 'Always ON.'

This guide was first published on Oct 12, 2021. It was last updated on Oct 12, 2021.

This page (Wiring) was last updated on Oct 07, 2021.

Text editor powered by tinymce.