Now that you've wired everything up and added your board to WipperSnapper, it's time to set the device itself up.

The very first thing you'll want to do is make sure that the device is online. Make sure that the box next to the device name is green and says 'Online.'

From the device page, click + New Component.

Then, click on the Power Switch.

Call it whatever you want. I chose to call it switch, but anything else should work as well. Finally, set Power Switch Tail Pin to D17.

Project Usage

Now, click on the toggle switch and as you turn it on and off, you should hear a click from the relay and see the electronic device you've plugged in turn on and off.

This guide was first published on Oct 12, 2021. It was last updated on Oct 12, 2021.

This page (WipperSnapper Setup) was last updated on Nov 28, 2021.

Text editor powered by tinymce.