Assuming you have already gone through the WipperSnapper Setup page and connected your board to WipperSnapper, navigate to the WipperSnapper board list.

On this page, select the WipperSnapper board you just connected.

• If you do not see your board listed - go back to the WipperSnapper Setup Page and make sure it registers with Adafruit.io

On the device page, quickly check that your device is online and is running the latest version of the WipperSnapper firmware.

The device tile on the left indicates the version number of the firmware running on the connected board.

• If the firmware version is green with a checkmark - continue with this guide.
• If the firmware version is red with an "X" - update to the latest WipperSnapper firmware on your board before continuing.

Adding Components

When you are on the new Barometer device page, start by adding the barometric pressure sensor. Click on either the New Component Button, or the big + icon in the middle of the page.

In the pop-up, search for NeoPixel and click on the NeoPixel option to get to the set-up screen.

On the next page, you will want to choose D21 from the NeoPixel Pin dropdown. Then change the Number of Pixels to 30 (that is how many are on this NeoPixel strip). You can leave the rest of the information set to the default.

Your Devices page should now look like this:

The next step will set up the Adafruit IO Actions to get this all to work.