Connect Switch
Get the toggle switch and connect it to the accompanying JST cable from the Prop-Maker FeatherWing.
Install Toggle Switch
The toggle switch is panel mounted to the side of the case. Locate the 6mm diameter hole on the side of the case. Insert the stem of the switch through the mounting hole. Press the body of the switch up against the wall.
Secure Toggle Switch
While holding the switch, insert the washer onto the stem. Begin to fasten the accompanying hex nut to the threading on the stem. Use pliers to tightly fasten the hex nut.
Panel Mounted Switch
The orientation of the toggle switch can be adjusted. The toggle switch can be positioned so it's flipped up/down or left/right depending on how you've mounted it. Note: This is the "power" switch – It will turn the device on and off. Adjust to your desired preference.
Text editor powered by tinymce.
