Install Button Elastomers

Get the 4x4 button elastomers and orient so the registration keys line up with the holes. Place the pad over the PCB and press down. Make sure the registration keys are fully seated.

Install Top Cover

Grab the top cover and orient so the cutout for the metal ball tactile button is lined up. Press down on the cover to snap fit into place. The cover features snap fit feathers that clamp shut.

Battery Tack

Use mounting tack/putty to secure the 1200mAh lipo battery to the bottom cover. The bottom cover features a dedicated spot for the battery.

Secure Battery

Orient the battery so the cable has enough slack to reach and maneuver.

Closing Bottom Cover

Handle the case and bottom cover and begin to close it up. Make sure the bottom cover is orientated so the battery can be fitted inside the case. Adjust the wiring as necessary. 

Final Build

Flip the switch to turn it on and test it out! The top and bottom covers can be removed using finger nails or praying tool. The battery can be recharged via the microUSB port.

This guide was first published on Jul 16, 2019. It was last updated on Mar 18, 2024.

This page (Final Assembly) was last updated on Mar 08, 2024.

Text editor powered by tinymce.