Install PropMaker to Feather
Get the Pro-Maker FeatherWing and snap it on top of the Feather M4 Express. Handle the wiring and components gently to avoid any stress or damage.
Connect Battery
Get the 1200mAh battery. Insert the cable through the bottom of the PCB mount. Reference the photo for correct placement. Plug in the JST connector from the battery to the battery port on the Feather M4 Express.
Connect Speaker
Get the case with the installed speaker. Grab the cable from the speaker and plug it into the speaker port on the top of the Prop-Maker FeatherWing.
Install PCB Mount
Get the PCB mount ready to install into the case. Orient the case and PCB mount so the Feather's USB port is lined up with the cut out on the case.
Installed PCB Mount
Place the PCB mount into the case at an angle. The speaker will be in the way so start with that side. Press the part down so it's flush with the tabs on the case. The Feather's USB port should be line up with the cutout on the case.
Setup Case
The PCB mount is loosely fitted inside the case. In the next page we'll secure the standoffs and finalize the rest of the assembly.
Page last edited March 08, 2024
Text editor powered by tinymce.
