ANO Rotary Breakout and Encoder Wheel
Install the rotary wheel to the ANO STEMMA QT breakout by orienting pins in the correct the holes.
Solder all of the pins on the ANO rotary encoder wheel to the ANO STEMMA QT breakout.
Slide Switch
Use the ribbon cable to create a 2-pin wire that is 6 inches / 15 cm in length.
Cut the pins on the slide switch so they're half their original length. Remove the third pin (either far left or right, but not the middle).
Solder the 2-pin wire to the two pins on the slide switch.
Feather Switch
Solder the 2-pin wire from the switch to the EN and GND pins on the bottom of the Feather RP2040.
NeoPixel Ring
Use the ribbon cable to create a 3-pin wire that is 12 inches / 30 cm in length.
Solder the 3-pin wire to the Data Input, GND, and PWR 5+V pins on the bottom of the 24x NeoPixel ring.
Connect NeoPixel Ring to Feather
Solder the 3-pin wire from the NeoPixel ring to the Feather RP2040.
- Data In from NeoPixel to Pin 5 on Feather
- GND from NeoPixel to GND on Feather
- PWR +5V from NeoPixel to 3V on Feather
Wired NeoPixel Ring
Take a moment to inspect the wires have been properly soldered to the pin on the Feather RP2040.
Connect ANO Rotary
Use the short STEMMA QT cable to connect the ANO rotary breakout to the Feather RP2040.
Text editor powered by tinymce.
