Install Slide Switch
Get the 3D printed PCB mount and circuit ready.
Insert the slide switch into the switch holder on the PCB mount by inserting it at an angle and fitting until it sits flush.
Install Feather
Place the Feather over the PCB Mount with the mounting holes in the correct orientation.
Use 4x M2.5 x 6mm long machine screws to secure the Feather to the PCB mount.
Install ANO Rotary
Place the ANO rotary breakout over the four tall standoffs with the mounting holes line up.
Secure ANO Rotary
Use 4x M2.5 x 6mm long machine screws to secure the ANO rotary breakout to the PCB mount.
Test Circuit
Use the slide switch to power on the Feather RP2040 and test out the circuit.
Turn off the Feather when ready to proceed.
Secure Bottom Cover
Place the PCB mount assembly over the bottom cover with the mounting holes and slide switch correctly oriented.
Use 4x M2.5 x 6mm long screws to secure the bottom cover to the PCB mount.
Install Case
Fit the 24x NeoPixel ring through the 3D printed case with the USB cutout properly oriented.
Secure NeoPixel Ring to Holder
Orient the 24x NeoPixel ring with the ring holder so the NeoPixel LEDs are fitted inside the spots in the grid.
Press fit the NeoPixel ring into the holder until it sits flush.
NeoPixel Wire
Adjust the 3-pin wire from the NeoPixel ring so they're fitted along the bottom of the PCB.
Installing Holder
Turn on the Feather RP2040 using the slide switch. Press one of the directional buttons on the ANO wheel to power a single NeoPixel LED.
Rotate the ring holder until the lit LED is lined up correctly with the directional button.
Secure Ring Holder
Press the ring holder down into the case until it is fully seating into the case.
Install Diffuser
Orient the 3D printed diffuser so the squares can be fitted into the ring holders grid.
Press the diffuser into the ring holder until it's been fully seated.
Final Build
Use the slide switch to turn the Feather RP2040 on and off.
Congratulations on your build!
Text editor powered by tinymce.