Cables for Push Button

Use a 2-pin molex cable to connect the push button to the QT Py. Measure and cut the wires down to size. Use the following lengths to trim the molex cables.

  • 2-pin molex – 9cm (3.5in)

Solder Wires to Push Button

Solder the two wires to the two pins on the push button. Polarity does not matter.

Wired Push Button

Double check the wires have been properly soldered to the pins on the push button.

This guide was first published on Nov 23, 2021. It was last updated on Mar 27, 2024.

This page (Wiring Push Button) was last updated on Mar 08, 2024.

Text editor powered by tinymce.