NeoPixel Bike Light

by Ruiz Brothers

published November 06, 2018, last updated November 06, 2018

posted in LEDs 3D Printing

Save Download

29

Beginner

Project guide

Switch Wiring

Switch Wires

The on/off toggle switch needs two wired connections. Male and Female 2-pin JST-PH cables are used here to make good use of quick connects. These cables are 70mm (2.8in) in length.

Solder Switch Wires

A set of third helping hands can assist in holding the switch in place while soldering the wires to the pins. The switch has three pins but we only need to use two of them. Solder wires to the middle pin and either the far left or right, as shown the photo.

Text editor powered by tinymce.

Search