Your button doesn't have to a circle, it can be what ever shape and size you want! Customize your buttons in Autodesk's 123D Design.
You can download the desktop app for free from Autodesk. Open our file and take a look at the parts that build up the design. To change the size, there is 4 parts that will need to be resized.
- Base Shell (23mm)
- Base Bottom (24mm)
- Cover Shell (24mm)
- Cover Bottom (25mm)
Our coat buttons have a diameter of 25mm. The cover piece will be seen on the front of the coat while the base piece is 2mm shorter so the cover piece snaps onto the base. To change the size of a part, select the object and click on the 'Scale' option in the bottom menu. Change the scale option to non-uniform and enter your desired size in the X and Y input boxes.
We uses these shapes to tightly secure the cover and base pieces together. To assemble the nubs, you will need to perform combine (subtract) to the (1)base shell and combine (join) the (3)cover shell. WIth the (1)base shell nubs subtracted, select the base shell object to highlight it. Select the top and bottom faces of the object and click the gear icon. In the hovering menu, select the shell function. Type 1mm into the input box and press enter. To combine (join) the two nubs onto the (3)cover shell, click combine, keep the option set to 'join' and select the shell and two nubs.
The (2)base bottom will need to be combined (join) to the (1)base shell. Move the shell down on the Z-axis until it touched the top surface of the base. The inner shell that is in center of the base will also need to be combined. The 4 ellipse shapes will need to be subtracted from the combined base so that the base and the NeoPixel can be sewed onto the coat.
- 12.8mm NeoPixel snap
For most FDM 3D printers, PLA material works with out a heated bed. Transparent PLA comes in a few different colors and there are different distributors.The extruder should be set to 230c. The model was design to print with a raft or any supports. It's a pretty small print so we recommend supervising the whole print since it only takes 5 minutes. Below is a small list of places to get PLA. Make sure your filaments diameter size matches your 3d printer. Most common size is 1.75mm and 3mm.
You will need to slice your STL file using the settings above. We recommend using MakerWare or ReplicatorG.
About 5 minutes
|Transparent PLA @230
2.0 Layer Height
Carefully remove the buttons you wish to replace from your coat using scissors. We need to sew the 3d printed button base to the coat. Start with the very top button, and work your way to the bottom. Place the base part over the area where the coat button was and sew the base onto the coat. You can use normal cotton thread. Once you them sewed onto the coat, test out the coat to see if the buttons are lose enough to button the coat.
The NeoPixels will snap onto the base. Make sure to align up the pin with the holes in the base. Notice how the holes in the base are longer than the pins of the NeoPixel. This is to allow conductive thread to be sewn to the NeoPixels. Make sure the data arrows of the NeoPixels are pointing upwards, towards the top.
Sew NeoPixelsConnect up the power, ground, and data pads on your NeoPixels with conductive thread, securing them inside the bottom half of the button. Take a look at our Conductive Thread guide as well as the Sparkle Skirt and Chameleon Scarf project guides for tips & techniques for sewing pixels with conductive thread.
The stitches should be a little loose, so that the button can lift a few millimeters away from the surface of the coat. But not so loose that the button can twist and short the threads!