Transparent PLA

For most FDM 3D printers, PLA material works with out a heated bed. Transparent PLA comes in a few different colors and there are different distributors.The extruder should be set to 230c. The model was design to print with a raft or any supports. It's a pretty small print so we recommend supervising the whole print since it only takes 5 minutes. Below is a small list of places to get PLA. Make sure your filaments diameter size matches your 3d printer. Most common size is 1.75mm and 3mm.


Slice STL

You will need to slice your STL file using the settings above. We recommend using MakerWare or ReplicatorG.
NeoButton Set
About 5 minutes
Transparent PLA @230
No Raft
No Support
2 shells
2.0 Layer Height

This guide was first published on Jan 15, 2014. It was last updated on Jan 15, 2014.

This page (3D Printing) was last updated on Jan 06, 2014.

Text editor powered by tinymce.