Hello NeoPixels!

Are you looking for an awesome blinky project? Do you like the idea of wearing RGB light spectrum on your wrists? Well, we have a project for you! This project is great for anyone that's getting started with electronics and 3D printing. This guide walks through the whole process of building this project so you can follow along step by step. The wiring, circuit diagram and code used in this project can easily be adapted for making other projects.

Trinket Powered

This slim bracelet is powered by a Trinket, mini skinny NeoPixel LED Strips and a rechargeable battery! The USB port is accessible from the side of the bracelet and uses a small but super strong magnets to keep it on while wearing!

Check out these improvements to neopixel bracelet in the forums:

Flat Braclet with Trinket M0

Parts

You'll need the following parts to build this project.

• Adafruit 5V Trinket
• Mini Skinny NeoPixel Strip (60m)
• 150mAh Lithuim polymer battery
• JST extension cable
• Slide Switch
• Micro Lipo w/MicroUSB Jack - USB LiIon/LiPoly charger

Tools & Supplies

You'll need the following tools and supplise to build this project.

• Soldering Iron & Solder
• Diagonal Flush Snips
• Helping Third Hands

Magnets & Paper Clip

We used these strong diametrically magnetized cylindical magnets:

• 1/8" dia. x 1/4" thick  Diametrical Magnets

We'll also need a paperclip to make a pin for the hinge.