This high-torque standard servo now comes in a metal-gear flavor, for extra-high torque (10 kg*cm!) and reliability! It can rotate at least 120 degrees (60 in each direction) with a classic 1.5-2.5ms pulse, but if you can extend your pulses it can go up to about 170 degrees - it varies a bit...

Plastic wheel with a cutout specially designed to allow attachment to our larger continuous rotation servo. Makes it easy to get your robot rolling. Each wheel comes with a rubber tire that is quite sturdy. To attach, just remove the horn...

This cable will let you turn a JST PH 3-pin cable port into 3 individual wires with high-quality 0.1" male header plugs on the end. We're carrying these to match up with our Hallowing, for extending and connecting sensors or LEDs - and the wires are even color coded!

Totaling 380 pieces, this M2.5 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel your maker tendencies for days on end! M2.5 size screws fit almost all of the Adafruit breakout/dev board mounting holes...

Whaddya got a screw loose or something?This is an industry standard 1/4" Photo Screw with a handy D-ring for tightening purposes. This will fit standard tripods, cameras, photo lights and more. The D-ring flips up to make it very easy to adjust by...

Cute as a button, these button-head hex screws are what we suggest for putting together a project with our slotted extruded aluminum. Use a 2.5mm hex wrench to attach/detach. This length is good for attaching something about 2mm/0.08" thick to 20x20 extrusion.Comes in a pack...

Keep your electronics from going barefoot, give them little rubber feet! These small sticky bumpers are our favorite accessory for any electronic kit or device. They are sticky, but not impossible to remove. They're small enough to fit onto any board, and have just enough height to give...