Wires for LIS3DH
Get the wires ready for the LIS3DH breakout board. Use the following wire lengths.
- 4-pin JST cable – 116m
- 4-wire ribbon cable - 250mm
Tin Ribbon Cable Wires
Use wire strippers to remove insulation from the tips of each wire. Tin the exposed wire using a bit of solder.
Tin 4-pin JST Cable
Use wire strippers to remove insulation from the tips of each wire in the 4-wire JST cable. Tin the strands of wire by adding a bit of solder.
Solder Ribbon Wires
Connect the 4-pin male JST connector to the 4-pin JST cable. Attach the wires from the ribbon cable to the 4-pin JST male connector. Make sure to add pieces of heat shrink tubing before soldering.
Solder LIS3DH Wires
Solder the wires from the ribbon cable to the pins on the LIS3DH breakout board. Reference pin outs and the colored wiring.
- Green Wire – SCL
- White Wire – SDA
- Red Wire – VIN
- Black Wire – GND
