Power Pins

  • Vin - this is the power pin. Since the sensor chip uses 3 VDC, we have included a voltage regulator on board that will take 3-5VDC and safely convert it down. To power the board, give it the same power as the logic level of your microcontroller - e.g. for a 5V microcontroller like Arduino, use 5V
  • 3Vo - this is the 3.3V output from the voltage regulator, you can grab up to 100mA from this if you like
  • GND - common ground for power and logic

I2C Logic Pins

  • SCL - this is the I2C clock pin, connect to your microcontroller's I2C clock line.
  • SDA - this is the I2C data pin, connect to your microcontroller's I2C data line
  • STEMMA QT - These connectors allow you to connectors to dev boards with STEMMA QT connectors or to other things with various associated accessories

Other Pins

  • INT -This is the interrupt pin. You can setup the MSA301 to pull this low when certain conditions are met such as taps being detected.

This guide was first published on Aug 23, 2019. It was last updated on Aug 23, 2019.

This page (Pinouts) was last updated on Oct 25, 2020.