The Adafruit Feather series gives you lots of options for a small, portable, rechargeable microcontroller board. Perfect for fitting into your next prop build! This FeatherWing will unlock the prop-maker inside all of us, with tons of stuff packed in to make sabers & swords, props, toys,...

Hear the good news! This wee speaker is a great addition to any audio project where you need 8 ohm impedance and 1W or less of power. We particularly like this speaker as it is small and comes with nice skinny wires with a connector on the end. It has a handy...

Lithium-ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light, and powerful. The output ranges from 4.2V when completely charged to 3.7V. This battery has a capacity of 400mAh for a total of about 1.9 Wh. If you need a larger (or smaller!)...

Squeeze once to turn on, squeeze again to turn off! This clicky switch makes a great power switch or mode toggler. We like this switch because it's easy to embed in a seam for easily powering up/off wearable and fabric projects. Can handle up to 14V and 2 Amps! This is a really satisfying...

If you need to add a panel-mount connection for USB Micro B,  but don't have the time or ability to cut a custom oval or square hole, this Round Panel Mount Extension Cable is the easiest and fastest way to panel-ify your existing micro-B USB kit. The...

Female header is like the duct tape of electronics. It's great for connecting things together, soldering to perf-boards, sockets for wires or break-away header, etc. We go through these real fast, and thought that given how handy they are, we'd offer them in a pack of five!Each...

In this world nothing can be said to be certain, except we need headers, headers, and more headers!Each pack contains ten red 36-pin 0.1" pitch break-away male headers.  These are a little extra special in that the plastic holding the pins...

Totaling 380 pieces, this M2.5 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel your maker tendencies for days on end! M2.5 size screws fit almost all of the Adafruit breakout/dev board mounting holes...