LED Strip Holder
The DotStar LED strip will be attached to the LED Strip Holder part with double-sided Nitto tape. Before that, the 4-pin cable will need to be threaded through the part.
LED Strip Cable
Insert the 4-pin cable from the DotStar LED strip through the hole on the LED Strip Holder part.
Pull the cable all the way through.
Secure LED Strip to Holder
Cut multiple pieces of the double-sided Nitto tape and carefully lay it on the flat side of the LED Strip Holder part.
Remove the protective backing from the pieces of tape.
Carefully lay the DotStar LED strip onto the tape with the edges nice and flush.
LED Arm Hardware
Use the following hardware to attach the LED Arm part to the LED Strip Holder part.
- 2x M3 x 10mm long nylon screw
- 2x M3 nylon hex nuts
Secure LED Arms
Place the LED Arm part under the mounting tab of the LED Strip Holder part.
Insert the M3 x 10mm long nylon screws through the mounting holes and secure the two parts using the nylon hex nuts.
Text editor powered by tinymce.
