Start Slide

Turn on the power, then press the rotary encoder to begin.

Move the carriage to either the far left or right side of the railing until the switch is actuated.

Start Pan Motor Angle

Turn the rotary encoder left or right to the desired starting angle. Press the rotary encoder to set this as the starting pan angle.

End Pan Motor Angle

Turn the rotary encoder left or right to the desired ending angle. Press the rotary encoder to set this as the ending pan angle. Wait for the motor to move back to the start angle.

Set Mode

Turn the rotary encoder to select either Timelapse or One Shot mode. Press the rotary encoder to choose the selected mode.

Timelapse Mode: Use for long captures. Options are 1, 5, 10, 15 and 30 minutes.

One Shot Mode: Use for short video clips. Options are slow (20 seconds), medium (15 seconds) and fast (10 seconds).

Go

Before starting the slide, take a moment to start video recording or trigger the timelapse on your camera.

Press the rotary encoder to start the stepper motors.

The stepper motors will go through their assigned motions and then stop when the carriage reaches the end of the rail, the panning motor reach the end position, and the end stop switch has been triggered. 

The display will return to the start screen. Repeat the setup progress to start a new session.