Shorten the wires from the stepper motors so they're 8.5in (21.6cm) in length.

Gather up the parts for the pan assembly. Parts include:

• Camera Plate
• Pan Bearing Mount
• Stepper Gear 16T
• Stepper Motor
• 6008ZZ 2RS ball bearing
• 1/4"-20 Tripod Screw / Rubber Washers
• 4x M3 x 6mm screws
• 4x M3 x 14mm screws
• 4x M3 hex nuts

Install Ball Bearing

Press fit the 6008-2RS into the center cavity of the pan bearing mount.

Install Stepper Motor

Place the stepper motor onto the pan mount with mounting holes lined up.

Insert and fasten the M3 x 6mm long screws to secure the stepper motor to the pan mount.

Stepper Motor Wires

Insert the wires from the stepper motor through the center of the ball bearing.

Install Tripod Screw

Insert the tripod screw through the center hole in the camera plate. Use the rubber washer to keep the screw in place.

Secure Camera Plate

Place the camera plate over the pan mount with the mounting holes lined up.

Insert the M3 x 14mm long screws through the camera plate standoffs and pan mount.

Use the M3 hex nuts to secure the parts together.

Install Pan Gear

Line up the 16T stepper gear with the shaft of the stepper motor.

Press fit the gear onto the shaft of the stepper motor.