Solder Slide Switch

Measure wires for the slide switch to reach where the Feather board mounts to the printed plate, about 120mm.

Speaker Socket Wire

Use Pico Blade socket wires to easily connect the oval speaker to the terminal block. 

Place board screws

Add screws to mount the Feather board to the standoffs on the plate part. Use M2x6mm screws for the screws holes close to the terminal block. Use M2.5x6mm screws for the screw holes next to the USB C port.

Mount Lipo Clip

Turn the printed plate over, behind the Feather, to mount the LiPo clip.

Use two M2.5mm screws to mount the Lipo clip to the center of the plate.

Mount Slide switch holder

Use two more M2.5mm screws to fasten the slide switch holder to the side of the plate.

Mount Slide Switch 

Pass the slide switch through the cut out on the plate.

The slide switch press fits at an angle into the holder.

Attach the Servo

Use the included screws to mount the servo to the tabs on the plate. Coil wires to fit between the servo and the terminal block.

Plug in a Right-Angle Female/Socket Header to the Feather to help fit the servo connector into the case.

Attach Lipo Battery

Slide the lipo battery into the clip part.

Place the battery wire to make it taut on the side of the plate and connect to the port on the Feather.

Attach Speaker

Plug the oval speaker into the Pico socket connector wire.

The speaker press fits into the cavity inside the case.

STEMMA QTcable

Pass the STEMMA QT cable through the cutout on the case to plug into the socket connector on the Feather.

Guide Rails

Place the assembled plate into the rails inside the case with the slide switch aligned to the cutout on the side of the case. 

Mount Sensor

Use M2.5x6mm screws to fasten to the sensor the standoffs on the case.

Assemble the Servo Horn

Measure and cut about 25 cm of Memory wire and bend into a curve.

Use a dark spray paint to help hide the wire.

Assemble Servo horn

Pass the wire through the printed wheel horn attachment and then into the inner holes on the included servo horn wheel. 

Use flat pliers to add a small bend to the end of the wire.

The servo horn wheel press fits into the printed attachment.

Attach bat

Thread the end of the wire through the printed bat.

Attach lid 

Align the cut out on the lid and press fit to the case.

Attach Servo horn

The assembled servo horn press fits onto servo shaft.