Solder QTPy 

Position the JST SM wires away from the edges of the QTPy board when soldering to help avoid the corners of the press-fit holder.

QTPy holder screws

Prepare the printed holder by attach two M2.5x6mm screws. 

Mount QTPy

Insert the QTPy with the STEMMA QT port first, then gently press on the USB connector to attach to the holder. 

Attach the case

Fasten the holder to the screw holes inside the case. Position the USB port to the cutout on the side on the case.

Measure LED strip

Use a tape measure to cut 55.3cm or 98 pixels. Start measuring after the socket connector and wires.  

Cut the strip along the center of the pad between the LEDs.

Connect strip

Align the socket and plug wires to connect the LED strip.

Press-fit LED strip

Align the start of the strip to the cut out along the channel inside the case. Press-fit a small portion of the strip into the channel. 

Insert the moon print at an angle to fit inside the case. Press each side until it sits below the LED channel.

Fit strip end

Gently press fit the rest of the strip in the channel, working your way from the start of the strip to the end.

Place cover

The LED cover helps to hide the LED strip and is fitted over the case.