Place Display

Align the ribbon cable to the cutouts inside the case.

Insert Mount Plate

The mounting plate snap-fits over the display at an angle to hold the display in place, with the stand offs facing up.

Gently bend the plate over the reset stem and then over the side tabs inside the case.

Attach ribbon cable

Gently open the ribbon latch on the Qualia board and align the ribbon cable to the port.

Mount Qualia

Use M2.5x6mm screws to mount the Qualia board to the standoffs on the mounting plate.

Attach Lid

First align two of the snap fits to the side tabs inside the case. Once the two walls are "locked-in", press fit the last tab to secure the lid.

Check USB port

Verify the USB port opening fits a USB cable. The mounting plate can rotate to adjust the USB port to the middle of the opening. 

Tripod screw

Use a flat tool to secure a 3/8" to 1/4" Adapter Screw to the thread on the lid.