Assemble the Pan Base

Save Subscribe
components_234A0915.jpg
  • Insert the servo into one side of the pan bracket.
  • Make sure that the servo shaft is at the opposite side from the pivot point for the tilt bracket
  • Assemble the second side of the pan bracket to enclose the servo.
  • Attach the two halves of the pan bracket using two screws as shown.
  • Attach the 4-armed servo horn to the servo shaft using one of the short screws as shown.
Use one of the shorter screws to attach the base to the servo shaft. The longer mounting screws packed with some servos will damage the servo if screwed in too far.
Tip: Align the servo horn so that the longer arms are vertical when the servo is at the midpoint of its rotation.
  • Attach the base to the servo horn, using 4 of the smallest screws as shown.
 Getting Started Assemble the Tilt Bracket 

This guide was first published on Aug 04, 2015. It was last updated on Aug 04, 2015.

This page (Assemble the Pan Base) was last updated on Aug 02, 2015.

Text editor powered by tinymce.