It doesn't take a long road trip to experience the joys of miniature golf. Just a few cardboard boxes, craft supplies, a couple of servos, and a Circuit Playground Express with CRICKIT programmed with MakeCode can bring a whole obstacle course to life.
Materials & Tools
To build this project, you will need:
- Medium-sized cardboard box (to make the course)
- Scrap pieces of cardboard (to make the obstacles)
- Scissors and/or X-acto knife
- Double-sided tape
- Popsicle sticks
- Golf ball (or ping pong ball) and golf putter
1 x
Adafruit CRICKIT for Circuit Playground Express
Creative Robotics and Interactive Construction Kit is an add-on to Circuit Playground Express that lets you #MakeRobotFriend using CircuitPython and MakeCode
1 x
Circuit Playground Express
Circuit Playground Express is the perfect introduction to electronics and programming
1 x
Micro servo
This little servo can rotate approximately 180 degrees (90 in each direction). Works just like standard servos you're used to, but smaller.
1 x
DC Gearbox Motor - "TT Motor" - 200RPM - 3 to 6VDC
TT DC Gearbox Motor with a gear ratio of 1:48 and 2 x 200mm wires with breadboard-friendly 0.1" male connectors
1 x
Alkaline AA batteries - 3 pack
These batteries are good quality at a good price, and work fantastic with any of the kits or projects that use AAs.
CRICKIT Assembly
If your Circuit Playground Express and CRICKIT aren't already connected, now is the time to do that.
The animation below demonstrates how the two become one.
Page last edited March 08, 2024
Text editor powered by tinymce.
