DC Jacks and Switches

Save Subscribe

Solenoid DC Jacks

Four DC jacks are used to connect the solenoids. These will be panel mounted to the enclosure. JST-PH female cables are soldered to each DC jack. The cables are approximately 30mm in length (1.2in).

DC Jack Polarity

Reference the photo for the correct polarity. The terminal with the large contact is VCC / voltage. The middle pin is not used. The remaining pin is ground.

Wire Switch and DC Jack

The toggle switch and 12VDC jack are wired to male JST-PH cables. These are also about 30mm in length (1.2in).

 PermaProto Wiring Solenoid Wiring 

This guide was first published on Aug 05, 2020. It was last updated on Jul 30, 2020.

This page (DC Jacks and Switches) was last updated on Aug 01, 2020.

Text editor powered by tinymce.