Install Perma-Proto to CoversThe wired Perma-Proto snap fits onto the bottom cover of the enclosure. Place the PCB over the standoffs and fit edge of the PCB under one of the tabs on the side. Press down to snap fit onto other tab. Adjust wires so the cables are not being kinked or pinched. |
|
Panel Mount DC JacksInstall the four DC jacks into the case by fitting them through the holes on the side of the enclosure frame. |
|
Panel Mount Switch and DC JackInsert the hex nuts onto the DC jacks and tightly fasten. Proceed to panel mount the toggle switch and the 12VDC jack for power input. |
|
Connect Switch and DC JackPlug in the toggle switch to the JST-PH connect that is connected to the EN and GND pins on the Feather. Plugin in the 12VDC power input to the JST-PH connector that is wired to the power and ground rails on the Perma-Proto PCB. |
|
Connect DC Jacks for SolenoidsPlug in the DC jacks for the solenoids to the various JST-PH connectors on the Perma-Proto PCB |
|
Install Case to CoverFit the enclosure frame over the bottom cover with the notch lined up with the USB port on the Feather. Check to ensure all of the wires are fitted inside the case. Firmly press to snap fit together. |
|
Install Top CoverPlace the top cover over the enclosure frame. Check to ensure all of the wires are fitted inside the case. Firmly press to snap fit close. |
Case Assembly
This guide was first published on Aug 05, 2020. It was last updated on Aug 05, 2020.
This page (Case Assembly) was last updated on Sep 05, 2020.