51
Beginner
Project guide
Overview
DIY MIDI Controller
3D Print and build your own MIDI foot pedal to create expression to your musical performances! Use CircuitPython and QT Py RP2040 to make a MIDI controller that you can assign to any MIDI CC!
MIDI Control Change
Use the MIDI library for CircuitPython to create a custom MIDI controller that can trigger and control MIDI CC's (control change). Use MIDI music software to assign your MIDI controller to any number of synths and effects to adjust parameters.
Prerequisite Guides
Take a moment to walk through the following guides.
Featured
Adafruit QT Py RP2040
What a cutie pie! Or is it... a QT Py? This diminutive dev board comes with one of our new favorite chip, the RP2040....
$9.95 each
In Stock
This Alpha 10K Linear potentiometer is a two-in-one, good in a breadboard or with a panel. It's a fairly standard...
No Longer Stocked
This cable is not only super-fashionable, with a woven pink and purple Blinka-like pattern, it's also made for USB C for...
Out of Stock
Totaling 420 pieces, this M3 Screw Set is a must-have for your...
$16.95 each
In Stock
Keep your electronics from going barefoot, give them little rubber feet! These small sticky bumpers are our favorite...
$0.95 each
In Stock
For those who are fans of our silicone-covered wires, but are always looking to up their wiring game. We now have...
Out of Stock
M3 x 16mm Screws
(×2)
M3 x 16mm Screws
M3 Lock Nuts
(×2)
M3 x 0.5mm Nylon Insert Lock Nut
Page last edited March 08, 2024
Text editor powered by tinymce.
