Play your favorite synths by finger drumming! Stitch up four piezos into a glove and use FLORA to transmit signals to your favorite music-making software.
Before you begin, read the Getting Started with FLORA guide! You'll have installed the Adafruit Arduino software by now, OR you can program your FLORA directly from your browser using Codebender. Fancy!
You may also want to brush up on your soldering skillz with our guide.
For this project you will need:
Before you begin, read the Getting Started with FLORA guide! You'll have installed the Adafruit Arduino software by now, OR you can program your FLORA directly from your browser using Codebender. Fancy!
You may also want to brush up on your soldering skillz with our guide.
For this project you will need:
- FLORA main board
- 4x small piezos
- USB miniB cable
- 4x 1M ohm resistors
- ribbon wire
- glove
- scrap fabric to match glove
- pencil
- soldering iron and solder
- third hand tool
- heat shrink tubing
- wire strippers, pliers, and flush diagonal cutters
- heat gun
- painter's tape or masking tape
- sewing needle and thread
- scissors
Text editor powered by tinymce.
